Fine Dryer Vents

For the large part of doing laundry, we rely on our dryers. After all, most of us do not have the time to spend hanging clothes out on a line, waiting hours for them to dry, then going out to remove them and then - finally - be able to fold and put away the items. dryer vent installation. Yes, that might work for a few types of clothing or perhaps linens, but after that, the sun-dried clothing routine becomes tedious.

Enter, modern technology and the clothes dryer. But, with this technology comes responsibility. There is being sure to get a large enough dryer to meet one's needs, being sure to use the correct products and most importantly, ensuring that the dryer vent is cleaned after every load of laundry AND that when the dryer is installed, that the vents are in properly placed.

dryer vent installation is not something to be taken lightly, though it is a job that most homeowners can do. There are specific things to consider in the process, else you risk usage challenges and even dryer vent related fires. So what is the proper way to install a dryer so that the dryer vents are placed properly? Here are the basic steps.

1. Determine where the dryer vent duct will run. Keep in mind that the shorter the distance and the fewer turns required the better it is. Also, a dryer vent running through the roof should be an absolute last resort. You will also want to avoid windows, outdoor obstructions and be sure that the duct work is at minimum of a foot off the ground and a foot away from obstructions such as decks or air conditioner units.

2. You need to use either galvanized steel or aluminum ductwork, but don't intermix the two- choose one! Be sure you also purchase an outdoor cap for the duct.

3. Use no more than 25 feet of 4-inch duct. You will need to subtract 5 feet for every 90-degree turn, 2.5 feet for every 45 degree turn.

4. Go outside and drill a pilot hole where you want the dryer vent to go. Be sure to check before drilling the hole to ensure there are no wires, ductwork or other home systems or any other hazards before drilling. Once you ensure the hole and the pat for the duct work will be efficient, make the vent hole larger. You can then caulk around the duct on the inside of the rim, and use the plastic trim ring to give a neater appearance.

5. Now install the ductwork. You can begin from the dryer site or from the site of the hole. Don't rely on tape to hold sections together. Use the metal foil tape designed for ductwork. TO give extra support, you can use plastic or metal pipe straps to help keep it rigid.

6. Finally, plug in the end of the duct. Be sure to place a dryer cap over the outside.

Dryer vent installation doesn't have to be a huge job, but you do want to be sure it is done correctly as this will ensure the dryer works efficiently and the risk of fire is minimized. If you are unsure of your skills, talk to a local dryer vent installation pro. In Apply Valley, the team at Dryer Vent Wizard will be happy to help or answer your questions. Dryers---what would we do without them!